<p>
<b><font face="Arial" size="2">APPLICATION METHODS:</font></b></p>
<p>
Low pressure, acid resistant tank sprayers are recommended.<br />
Regardless of application method, avoid inhalation of mist or contact of liquid or mist with skin.</p>
<p>
<b><font face="Arial" size="2">SUGGESTED INSTRUCTIONS FOR USE:</font></b></p>
<ul>
<li>
<font face="Arial" size="2"> When handling RXSOL-16-1697-005 or any other strong chemical, be sure to wear chemical impervious</font><font face="Arial" size="2">gloves,apron and splash goggles.</font><br />
 </li>
<li>
<font face="Arial" size="2">Determine required dilution ratio for the specific application. It is recommended to start with a dilution ratio of 10:1 and increase concentration until the desired results are achieved.</font><br />
 </li>
<li>
<font face="Arial" size="2">As with mixing all acids, place the desired amount of water into the tank and then add RXSOL-16-1697-005.</font><br />
 </li>
<li>
<font face="Arial" size="2">  Turn off fans and allow hot coils to cool before applying.</font><br />
 </li>
<li>
<font face="Arial" size="2">Using plain water, wet both the condenser coil as well as the area surrounding the equipment. Wetting the coil with water aids in product penetration and performance.</font><br />
 </li>
<li>
<font face="Arial" size="2">Apply the properly diluted product to the coil surface. Whenever possible, apply solution from the outlet side of the coil. Allow product to remain on surface, normally 5-10 minutes. Do not allow product to dry on the coil. Note: In extreme cases, application may have to be repeated to achieve</font><font size="2"><font face="Arial"> </font></font>desired results.</li>
<li>
<font face="Arial" size="2">If foaming does not occur, check for extreme grease buildup which will slow cleaning process. Foaming may not occur if coil is coated or painted.</font><br />
 </li>
<li>
<font face="Arial" size="2">  Rinse coils, tools and surrounding area thoroughly after completing the coil cleaning process</font></li>
</ul>