First of all, flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-16-3014 is by direct injection followed by recirculation washing, using tank cleaning machines.

Spraying method: Directly spray on the contaminated area and let it act for 5-10 minutes. Then clean the system under high pressure. A solution of 5-10% in fresh water can be used for this purpose also, and may be sprayed on and hosed off using high pressure.

Circulation method: Cleaning the oil side of the tank can be cleaned by circulating through with RXSOL-16-3014.

Rock and Roll method: fill the tank with water (fresh or sea) up to 25 - 30% of its volume than 5–20% (Depend on contamination) RXSOL-16-3014 will add, let it stand for approximately 12-24 hours. Then fill with more water to 90% of the tank's capacity. This way the tank will be cleaned by natural agitation due to wave motion. Let for a few days, then drain the tank and ballast-deballast 2-3 times in order to achieve complete and thorough rinse off.